Introduction This sheet will guide you through the basic steps needed to install the 2-Port KVM Switch with Built-In Cabling (the Switch). If you have any problems during installation, please refer to the User Manual.
Connecting the Keyboard, Video, and Mouse to the Console Ports on the Switch
1. Power down all computers. 2. Connect your PS/2-type keyboard and mouse to the KEYBOARD and MOUSE ports located on the front panel of your Switch. 3. Take the video cable that is attached to your monitor and connect it to the VGA port on the front panel of the Switch.
Connecting Computers to the Switch
1. Using the attached cables, take the VGA cable and connect it to the VGA port on the first computer. 2. Connect the PS/2 keyboard KVM cable to the keyboard port on the computer. 3. Connect the PS/2 mouse KVM cable to the mouse port on the computer.
You will need the following items to install the Switch: • 2-Port KVM Switch with Built-In Cabling • One (each) keyboard, monitor, and mouse
Repeat Steps 1 through 3 for the additional computer to be connected to the Switch.
Power on your Computers Belkin Corporation
Power up your computers. You are now ready to use your Switch. Please refer to your User Manual for additional information.
501 West Walnut Street Compton • CA • 90220 • USA Tel: 310.898.1100 Fax: 310.898.1111
Belkin Components, Ltd. Express Business Park • Shipton Way • Rushden NN10 6GL • United Kingdom Tel: +44 (0) 1933 35 2000 Fax: +44 (0) 1933 31 2000
Belkin Components B.V. Starparc Building • Boeing Avenue 333 1119 PH Schiphol-Rijk • The Netherlands Tel: +31 (0) 20 654 7300 Fax: +31 (0) 20 654 7349
2-Port KVM Switch with Built-In Cabling Control two computers using one video monitor, and a PS/2 keyboard and mouse